FPV builds, custom quads, soldering, board swaps, and custom 3D printed parts. If it's fixable, we'll fix it.
We'll inspect your drone, identify the issue, and give you a repair estimate. If you proceed with the repair, the diagnostic fee is applied toward the total cost.
Soldering, board swaps, motor replacements, wiring, firmware flashing, tuning, and more. Parts billed separately at cost + 15%.
Custom mounts, replacement frame parts, GoPro mounts, antenna holders, landing gear, lens protectors, and more. Custom designs available.
Diagnostic fee waived if you proceed with repair. Most repairs fall in the $80–$150 range (parts + labor).
Custom builds, FPV quads, and drones with off-the-shelf parts we can source.
Burnt ESCs, dead FCs, upgrade installs
Bent shafts, dead windings, bearing failures
Broken pads, cold joints, rewires, connector swaps
ELRS, Crossfire, DJI, analog VTX setup and binding
Betaflight, iNav, ArduPilot config and PID tuning
Crash damage, arm replacements, full rebuilds
GPS module replacements, barometer, compass issues
Custom mounts, replacement parts, accessories, prototyping
Fill out the form below and we'll get back to you within 24 hours with a rough estimate.